Easy To Install |
 |
STEP 1
Measure window for sleeve locations and panel size. Cut panels 5/8” smaller both vertically and horizontally for best fit. |
 |
STEP 2 Mark the panel as to where you want each clamp making sure you have an equal number evenly spaced on each side. Tighten each clamp on the panel using a #2 Phillips screw driver. |
 |
STEP 3 Mark each location where clamp is going to be placed. Drill hole for sleeve using a 7/16 bit. Insert sleeve with hammer. We recommend drilling hole minimum 1 1/4” from face of building. |
 |
STEP 4 Replace the panel and clamps back into the opening. Adjust the position of the clamps to align the pin with the hole. Rotate the pin into its locked position. |
TOOLS NEEDED FOR INSTALLATION
|
|
-
Hammer Drill
-
Phillips #2 Screw Driver
|
Complete Detailed Instructions Inside |
|